|
|
EVERY SYSTEM IS DIFFERENT, YOU MAY NEED TO TURN AN ADDITIONAL VALVE HERE OR THERE, THIS WILL BE SHOWN TO YOU UPON INSTALLATION.
Open the sludge drain (the bottom valve on the filter blue or yellow handle) with the pump running and the filter still in the “filter” position. After a few seconds close the sludge drain.
Turn off Pump, open leaf basket on pump, remove basket and clean. Replace basket, and fill basket with water, if is not already full. Replace top making sure the seal is solid, turn on pump and verify water is flowing.
Turn off the pump, move the filter head valve (FHV) to the RINSE position, turn blower valve (red handle) on Aquadyne filters, turn on blower for 2-3 minutes. (You must hear the beads smashing around for 2-3 min, if not turn the blower on and off a few times to break the beads apart) Turn blower off.
Move FHV to BACKWASH and restart the pump for 1-2 minutes until water is clear in the sight glass. Turn off pump.
Move FHV to RINSE restart pump, run for a short while until water is clear in the sight glass. Turn off pump
Move FHV to filter, restart pump.
Replenish pond water to desired level, ADD DECHLORINATOR (Amquel) if you are not on a well. Well owners should use something to eliminate heavy metals like Novaqua.
Sit back and enjoy your pond.
|
|
|
